Discount Grease Trap Service
We make it worth your while when you trust in our services.
We clean grease traps at a discounted price for all our customers.
- Free Set Up
- Fast Clean Service
We leave the area cleaner than when we got there!
Guaranteed to pay top dollar - always beating our competition
Respectable service - your area is left cleaner than when we arrived
Every set-up is free
Secured tanks free of change
Equipment is free
Willing to give the best quote on your grease trap cleaning
Ask about our pricing - 30 years in the business!
Save quarterly by having one company do it all
Traps of all sizes pumped at lowest rates around
Expect quality from our family owned business
With new city ordinances/regulations imposed by the City of Houston, which now require all grease traps to be pumped and cleaned at least QUARTERLY.
To offset your grease trap expense and even get paid for it!
Sec. 47-512. Cleaning and maintenance requirements.
- Generators shall clean or cause to be cleaned, each interceptor and holding tank as often as necessary to comply with the effluent discharge parameters in this article to ensure that sediment and floating materials do not impair the efficiency of the interceptor, and to ensure that no visible fat, oil or grease (FOG) is observed in the sample well.
- Each interceptor or holding tank shall be fully evacuated at least once every 90 days.
- Each interceptor or holding tank shall be fully evacuated more frequently than once every 90 days when:
- Twenty-five percent or more of the wetted height of the grease trap or interceptor, as measured from the bottom of the device to the invert of the outlet pipe, contained floating materials, sediment, oils or greases; or
- The discharge exceeds the discharge parameter set in this article;
- There is history of non-compliance.
The Houston Health department recommends that you inspect your grease trap every time that it is pumped out . Here is what you should look for:
- Your trap should be empty, you should be able to see the bottom of the trap. If their are a few large rocks or concrete chunks at the bottom that is not a big issue they could have been left from a sloppy install. Large objects such as this can not be sucked up through a vacuum hose on a typical truck. They will have to be removed manually.
- Look for any cracks or breaks in the trap itself. If the cracks or breaks are in the baffles you may have future issues with grease passing through your trap and into the lines going to the city. If this happens the line past the trap may back up causing your trap to explode (over flow) on to the surrounding grass parking lot etc. At that point the city may get involved issues warnings or fines the state(TCEQ) may get involved as well. Trust me this is no fun! Then you have the emergency pump out the emergency plumbing call and a possible remediation company. These things are also no fun and can be quit expensive.
- Check the walls of your trap especially near the top where the grease collects. Take a close look at the corners (this is where contractors cut “corners”)there should be no grease caked on to any area of your trap. Your walls should be washed down with a pressure washer as well.
- Check the plumbing for breaks cracks etc. There should be a pipe on the outflow side of the trap that reaches close to the bottom of the trap which allows clean water to exit the trap grease free and out to the sample well.
- Inspectors look at your sample well and you should too. This is a window to your grease trap soul! If you see grease caked to the walls of yous sample well or you see particulate floating in your waste stream you probably need to pump out more frequently. Remember, it is better to figure this out on your own rather than being told by an inspector to do it. It keeps them happy and that should make your life easier as well. (no ticket means no ticket, no court ,no fine etc)